Help centre

Frequently asked questions

Everything about calibration, accuracy, true north, the level, the direction finder and your privacy. Can't find your answer? Contact us.

General

What is the Compass app?

Compass (full name Compass: Level & Direction) is an Android app that combines a compass, a bubble level and inclinometer, a direction finder and a list of saved bearings. Its main difference from other compass apps is that it checks its own sensor and tells you, in plain words, when a reading may be wrong and how to fix it.

Does Compass have ads or require an account?

No. There are no ads, no in-app purchases in the app and no sign-up. You open it and it works.

Which phones and tablets are supported?

Compass runs on Android 7.0 (Nougat) and later, on phones and tablets, in portrait and landscape. For the compass you need a phone with a magnetometer; for the level, an accelerometer. Most Android phones have both. If a sensor is missing, the app shows a clear "unavailable" message for that tool and the others keep working.

Does Compass work offline?

Yes. The compass, level, direction finder, saved bearings, true north, coordinates and elevation all work without internet. Only three things need a connection: the optional city name, receiving notifications, and sending usage statistics and crash reports (which wait until you're back online and never block a tool).

Is there an iPhone version?

Not at the moment. Compass is available for Android only.

Which languages are available?

The app is currently in English only.

Accuracy & calibration

How accurate is the compass?

Compass shows exactly what your phone's sensors measure, rounded to whole degrees, and smooths the movement so the dial doesn't jump. Its accuracy is limited by your phone's magnetometer, so we don't promise a fixed figure. What the app does guarantee is honesty: it checks the sensor's accuracy, the field strength and, with your location, the match with the Earth's field, and warns you whenever one of them looks wrong.

How do I calibrate my phone's compass?

When Compass shows Calibration needed, tap it to open the calibration guide, then:

  1. Move away from metal, magnets, laptops, speakers and cars.
  2. Remove a magnetic case or mount if you use one.
  3. Hold the phone and slowly trace a figure-8 in the air a few times, turning your wrist so the phone points in different directions.
  4. Watch the live status in the sheet; it updates as the sensor recalibrates.

You can open the same guide any time from Settings → Calibration help.

What does "Interference" mean?

The Earth's magnetic field is normally about 20–70 microtesla (µT). If your phone measures a field much stronger or weaker than that, something nearby is distorting it: a laptop, speaker, magnet, metal table, car, or a magnetic phone case or mount. Move a few steps away from it and the warning clears on its own.

What does "Check calibration" mean?

When your location is available, Compass compares the magnetic field your phone measures (its strength and its downward "dip" angle) with what the World Magnetic Model expects for that place. If they differ a lot (more than about 15° of dip or 15 µT of strength), your phone's own sensor calibration is probably off, even if Android says it's fine. Follow the figure-8 steps and move away from metal.

Why does the heading change when I tilt the phone?

Held flat, Compass shows the direction of the top edge of the phone. Held upright, it shows the direction the back camera faces. In between, it blends the two smoothly. This is intended, so the reading always matches the way you're naturally pointing the phone.

Why does Compass show a different heading from another app?

Usually it's one of three things: one app uses true north and the other magnetic north (the difference is your local declination); the other app measures a different edge of the phone; or the sensor needs calibrating and only Compass is telling you. Check the north chip at the top of the screen, and look for any warning.

True north & location

What is the difference between true north and magnetic north?

True north points to the geographic North Pole, which is what maps and GPS use. Magnetic north is where a compass needle points, and it moves over time. The angle between them is called magnetic declination and depends on where you are; in some places it's more than 10°. Compass can show either. For true north it adds your local declination, calculated on the phone with the World Magnetic Model built into Android.

Why does true north need my location?

Declination is different in every place, so Compass needs to know roughly where you are to calculate it. Approximate location is enough. Until there's a fix, the compass stays on magnetic north and says so ("Magnetic · finding location"), so it never labels a heading "true" when it isn't.

Is my location stored or shared?

No. Location is used only while a screen that needs it is open (or while true north is on), and it is never saved. It is not included in usage statistics. The only time coordinates leave your phone is if you turn on Show place name, which sends them to your phone's built-in geocoding service to look up the city. That switch is off by default. See the privacy policy.

How is elevation measured?

Elevation comes from your phone's GPS. On Android 14 and later it is shown as height above sea level. On older versions the app shows the GPS height and marks it as approximate, because GPS height and sea level can differ by tens of metres.

Can I copy my coordinates?

Yes. Open the North & location panel (tap the location card or the north chip), choose decimal degrees or degrees-minutes-seconds, and tap Copy coordinates.

Level & inclinometer

What are Surface, Edge and Auto modes?

Surface is a bubble level: lay the phone flat to check a table or shelf in two directions (pitch and roll). Edge is a tube level: stand the phone on its side against a frame or worktop. Auto switches between them for you as you pick the phone up or lay it down.

My level isn't showing 0° on a flat surface. How do I fix it?

Phone cases and camera bumps can tilt the phone slightly. Put the phone on a surface you know is level, keep it still, and tap Calibrate → Set zero. Compass stores a separate zero for Surface and Edge modes. Tap Reset to remove it. Set zero only accepts small corrections (up to 5°), so it can't be used to hide a real tilt by mistake.

Can I change when the level says "Level"?

Yes. In Settings → Level tolerance choose anything from ±0.1° to ±2.0° (the default is ±0.5°). The phone vibrates once when it becomes level, if haptic feedback is on.

Direction finder & bearings

How do I use the direction finder?

Open it from the Compass screen. Set a target by using your current heading, typing a bearing (0–360°, or N, NE, E, SE, S, SW, W, NW) or choosing a saved bearing. The arrow and the text tell you which way to turn and by how much, and the screen shows On target when you're within your chosen tolerance (±3° by default, adjustable from 1° to 10°).

Can I use Compass to face a specific direction, like the Qibla?

If you know the bearing you need, yes: type it into the direction finder and follow the arrow until it reads "On target", and save it for next time. Compass doesn't calculate religious directions for you, so get the bearing for your location from a source you trust, and check whether it's given relative to true or magnetic north.

Will the direction finder guide me along a route?

No. A bearing is a straight line, not a route around buildings, rivers or cliffs. The app reminds you of this on screen. Use a map for route planning and Compass to check your direction.

Where are my saved bearings stored?

Only on your phone. If Android device backup is turned on, they're included in your own Google backup, so they come back when you restore to a new phone. Deleting a bearing in the app removes it; uninstalling the app removes all of them.

Privacy & data

What data does Compass collect?

Compass uses Google Firebase to count which features are used (Analytics), to report crashes (Crashlytics) and to receive notifications (Cloud Messaging). This data is not linked to your name or an account, and never includes your location, coordinates, bearing names, descriptions or notification text. Sensor readings stay in memory and are never stored. Full details are in the privacy policy.

How do I turn off usage statistics?

Open Settings and turn off Share usage data. This stops both usage statistics and crash reports from being collected. Every tool keeps working exactly the same.

What notifications does Compass send?

Occasional app news, tips and update notices. They're kept in the in-app notification inbox (the bell icon) so you can read them later, and you can delete them at any time. On Android 13 and later, Compass asks for notification permission only when you choose to turn them on from the inbox.

Troubleshooting

The compass says it's unavailable. What can I do?

This means your phone doesn't report a magnetometer (or the sensor couldn't be started). Some low-cost phones don't have one, and no app can show a real compass without it. Compass refuses to show a made-up number. The level and the other tools still work if your phone has an accelerometer.

The level keeps saying "Hold still".

The level waits for the phone to stop moving before it gives a reading, so the number isn't distorted by motion. Rest the phone on the surface and let go; the reading appears as soon as it settles.

How can I report a bug or suggest a feature?

Use the contact page. Please include your phone model, Android version and the app version (shown in Settings → Version), and what you saw on screen.

No questions match your search. Try another word, or ask us directly.

Still have a question?

Send us a message with your phone model and Android version and we'll help you get accurate readings.